Aqua36 B Hydroponic Propagation System – 60 × 40 cm

36 planting positions for propagation and cultivation in nutrient solution. Aqua36 B includes clay granules and 300 g of starter fertiliser. No aeration unit is included.

1. Position the system

   Position the reservoir level. Insert the water-level indicator into the lid from below and fit the lid.

2. Prepare the pots

   Prepare the 36 pots outside the system with clay granules and suitable plants. Rinse with clean water before inserting them to remove loose particles.

3. Prepare nutrient solution

   Measure 1 g of starter fertiliser per litre of water, for example 10 g per 10 L. Dissolve while stirring for 2–3 minutes. At this dose, 300 g makes 300 L.

4. Set the water level

   Insert the pots. Without aeration, keep the water level midway between minimum and maximum; in the standard system this is approximately 10 L.

5. Monitor the crop

   Check the water level regularly and stir the nutrient solution vigorously at least once a day. Prepare top-up nutrient solution separately at the same 1 g/L ratio and consider the crop’s requirements.

6. Replace water and clean

   Replace water after approximately 2 weeks. Clean the reservoir regularly, at least every 4 weeks, with clean water or neutral soap.

Item code

Aqua36-B

Contents

Water reservoir, hinged cover, 36 plant pots, water-level indicator, 2.5 L clay granules, 300 g starter fertiliser. No pump included. Plants not included.

Footprint

60 × 40 cm

Starter fertiliser

NPK(MgO,SO₃) 14–10–14 (+2+30)

Declaration

14% total nitrogen (N): 4% nitrate nitrogen, 10% ammonium nitrogen.

Declaration

10% water-soluble phosphate (P₂O₅); 14% water-soluble potassium oxide (K₂O).

Declaration

2% water-soluble magnesium oxide (MgO); 30% water-soluble sulphur trioxide (SO₃).

Declaration

0.01% water-soluble boron (B) as boric acid; 0.001% water-soluble molybdenum (Mo) as ammonium molybdate.

Declaration

0.02% copper (Cu), 0.05% iron (Fe), 0.05% manganese (Mn), 0.02% zinc (Zn), each water-soluble and chelated by EDTA.

Declaration

Low in chloride. Chelate stability at pH 3–7. Net mass of starter fertiliser: 300 g.

Match light, temperature and nutrient demand to the crop. Check water level and root condition regularly. No fixed unattended supply duration is promised.

At 25 °C, 1 g/L starter fertiliser increases EC by approximately 1.6 mS/cm; this is not a universal target independent of the source water. A 1:10 stock solution in distilled water has pH 4.0 at 25 °C.

• Apply fertiliser according to actual requirements; do not exceed application rates. Intended for horticultural soil and foliar fertilisation.
• General label range outside the Aqua starting programme described here: liquid feeding 0.5–4 ‰, foliar feeding 0.5–2 ‰, according to growth stage and tolerance. The Aqua starting dose is 1 g/L.
• German Hazardous Substances Ordinance: ammonium nitrate, Group C III.
• Keep water-bearing systems away from electrical installations; escaping water must not reach electrical equipment.

Store starter fertiliser dry and dark, above 8 °C and no higher than 38 °C, out of reach of children and animals.

Clean the system after the crop. See the application section for routine cleaning.