Greenhouse insulation set 7.5 m² – film, 20 holders & adhesive

Measure the surfaces to be insulated and plan the cutting of the 150 cm wide film. 7.5 m² is the supplied film area, not the greenhouse floor area.

Clean the bonding surfaces. Apply adhesive to a suitable holder base and press the holder onto a suitable glass or aluminium greenhouse surface. Follow the material and application instructions for the supplied version.

Allow the adhesive to cure fully before loading. Then place the film over the threaded tip of the holder and secure it mechanically with the screw cap. Do not glue the insulation film directly.

Dichtkleber 545862 is not suitable for PE, PP or PTFE. Check that the bonding surfaces are suitable; do not use in permanent contact with water.

Depending on availability, exactly one white 80 ml tube (120 g) of fischer Montagekleber 545864 or fischer Dichtkleber 545862 is supplied. The images show the two possible versions; both tubes are not included.

• 7.5 m² three-layer PRO3 bubble insulation film
• 20 film holders
• 1 white 80 ml tube (120 g) of fischer Montagekleber 545864 or fischer Dichtkleber 545862, subject to availability

Store adhesive in a cool, well-ventilated place at 5–25 °C. Follow the instructions on the original packaging supplied.

Store the film dry and protected from direct sunlight; keep the holders in their original packaging. Do not pull the film over sharp edges.

• EUH208 – Contains trimethoxyvinylsilane. May produce an allergic reaction.
• EUH210 – Safety data sheet available on request.
• Ensure good workplace ventilation and avoid eye and skin contact. Follow the information on the original packaging supplied.